Hyundai Venue: Clutch System / Ignition Lock Switch
Hyundai Venue (QX) (2020-2025) Service Manual / Clutch System / Ignition Lock Switch
- Specifications
- Description and operation
- Repair procedures
- Clutch Switch. Specifications
- Clutch Switch. Description and operation
- Clutch Switch. Repair procedures
- Clutch Pedal. Components and components location
- Clutch Pedal. Repair procedures
- Clutch Tube. Components and components location
- Clutch Tube. Repair procedures
- Clutch Master Cylinder. Components and components location
- Clutch Master Cylinder. Repair procedures
- Concentric Slave Cylinder Assembly. Repair procedures
Repair procedures
Removal
1.
Remove the manual transaxle assembly.
(Refer to Manual Transaxle System - "Manual Transaxle")
2...
Specifications
Specifications
Item
Specifications
Working voltage
DC 12.5V ± 0.3V
Operating force
Initial position : 0...
Other information:
Hyundai Venue (QX) (2020-2025) Service Manual: Transaxle Control Module (TCM). Description and operation
Description • Monitors the vehicle's operating conditions to determine the optimal gear setting. • Performs a gear change if the current gear setting differs from the identified optimal gear setting...
Hyundai Venue (QX) (2020-2025) Service Manual: Schematic diagrams
Terminal Function Pin No Description Current (AMPS) Resistance (mΩ) Remark 1 POS. BATTERY 2. (MOTOR) 40A 10 2 - 3 - 4 C-CAN Low 100 mA 250 5 C-CAN High 100 mA 250 6 - 7 P-CAN Low 100 mA 250 8 P-CAN High 100 mA 250 9 SENSOR REAR LEFT POWER 150 mA 250 10 SENSOR REAR RIGHT POWER 150 mA 250 11 SENSOR FRONT RIGHT POWER 150 mA 250 12 SENSOR FRONT LEFT POWER 150 mA 250 13 PUMP MOTOR GROUND 40A 10 14 - 15 CLUTCH SWITCH SIGNAL 1...
Categories
- Manuals Home
- 1st Generation Venue Owners Manual
- 1st Generation Venue Service Manual
- Vehicle Identification Number (vin), Vehicle Certification Label
- Automatic Door Lock and Unlock Features
- Theft-Alarm System
- New on site
- Most important about car
Air bag collision sensors
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:
Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Do not install bumper guards or replace the bumper with a nongenuine HYUNDAI parts. This may adversely affect the collision and air bag deployment performance. Place the ignition switch in the LOCK/OFF or ACC position when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs conducted by an authorized HYUNDAI dealer.
Copyright © 2025 www.hvenueqx.com