Hyundai Venue: Driveshaft and axle
Hyundai Venue (QX) (2020-2024) Service Manual / Driveshaft and axle
- Specifications
- Special service tools
- Troubleshooting
- Front Hub / Knuckle
- Driveshaft Assembly
- Front Driveshaft. Components and components location
- Front Driveshaft. Repair procedures
- Dynamic Damper. Components and components location
- Dynamic Damper. Repair procedures
- TJ Joint. Components and components location
- TJ Joint. Repair procedures
- BJ Boot. Components and components location
- BJ Boot. Repair procedures
- Rear Hub - Carrier
Shift Cable. Repair procedures
Removal
1.
Turn OFF ignition switch and then diconnect the battery negative (-)
cable.
2.
Remove the air cleaner and air duct...
Specifications
Specification
Engine
Tramsaxle
Max. permissible angle
Outer
Inner
Gamma 1...
Other information:
Hyundai Venue (QX) (2020-2024) Service Manual: Repair procedures
Removal 1. Remove the front bumper cover. (Refer to Body - "Front Bumper Cover") 2. Disconnect the multifunction switch connector and then remove the low horn (A). Installation 1...
Hyundai Venue (QX) (2020-2024) Service Manual: SS-A Solenoid Valve (ON/OFF). Specifications
Specifications ▷ Control type : Normally low type Shape Items Specifications Control current (voltage) [V] 9 - 16 Supply pressure [kpa (kgf/cm², psi)] 490...
Categories
- Manuals Home
- 1st Generation Venue Owners Manual
- 1st Generation Venue Service Manual
- To set Cruise Control speed
- Operating Door Locks from Outside the Vehicle
- Lighting control
- New on site
- Most important about car
Remote Key
Your HYUNDAI uses a remote key, which you can use to lock or unlock the driver and passenger doors or the rear liftgate.
(1) Door Lock
(2) Door Unlock
(3) Panic
Locking Your Vehicle
To lock your vehicle:
1. Make sure all doors, the engine hood and the liftgate are closed.
Copyright © 2024 www.hvenueqx.com