Hyundai Venue: Driveshaft and axle / Driveshaft Assembly
Hyundai Venue (QX) (2020-2025) Service Manual / Driveshaft and axle / Driveshaft Assembly
- Front Driveshaft. Components and components location
- Front Driveshaft. Repair procedures
- Dynamic Damper. Components and components location
- Dynamic Damper. Repair procedures
- TJ Joint. Components and components location
- TJ Joint. Repair procedures
- BJ Boot. Components and components location
- BJ Boot. Repair procedures
Repair procedures
Removal
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2...
Other information:
Hyundai Venue (QX) (2020-2025) Owners Manual: Intelligent Variable Transmission (IVT) Operation
The Intelligent Variable Transmission (IVT) automatically shifts depending on speed, accelerate pedal position. The individual speeds are selected automatically, depending on the position of the shift lever. WARNING To reduce the risk of serious injury or death: ALWAYS check the surrounding areas near your vehicle for people, especially children, before shifting a vehicle into D (Drive) or R (Reverse)...
Hyundai Venue (QX) (2020-2025) Service Manual: Repair procedures
Removal 1. Disconnect the battery nagative terminal. 2. Remove the engine cover. 3. Disconnect the ignition coil connectors (A). • When removing the ignition coil connector, pull the lock pin (A) and push the clip (B)...
Categories
- Manuals Home
- 1st Generation Venue Owners Manual
- 1st Generation Venue Service Manual
- System Setting and Activation
- Operating Door Locks from Outside the Vehicle
- Warning and Indicator Lights
- New on site
- Most important about car
Air bag collision sensors
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:
Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Do not install bumper guards or replace the bumper with a nongenuine HYUNDAI parts. This may adversely affect the collision and air bag deployment performance. Place the ignition switch in the LOCK/OFF or ACC position when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs conducted by an authorized HYUNDAI dealer.
Copyright © 2025 www.hvenueqx.com