| Components |


Inspection 1. Troubleshooting for Speaker (1) Basic inspection of speaker Inspect the sound from speaker after verifying that the speaker mounting screws is removed and the wiring connector is connected precisely to remove vibration transmitted from body trims and surrounding parts.
Removal 1. Remove the rear roof trim. (Refer to Body - "Roof Trim Assembly") 2. Disconnect the roof antenna cable and connector (A) and then remove the antenna mounting nut (B).
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.