| Removal |
| 1. |
Disconnect the battery negative cable and wait for at least three minutes
before beginning work.
|
| 2. |
Remove the door scuff trim.
(Refer to Body - "Interior Trim")
|
| 3. |
Remove the center pillar trim.
(Refer to Body - "Interior Trim")
|
| 4. |
Loosen the side impact sensor mounting bolt (A) and remove the side
impact sensor.
|
| Installation |
|
| 1. |
Install the new side impact sensor with the bolt (A) then connect the
side impact sensor connector.
|
| 2. |
Install the center pillar trim.
(Refer to Body - "Interior Tirm")
|
| 3. |
Install the door scuff trim.
(Refer to Body - "Interior Tirm")
|
| 4. |
Reconnect the battery negative cable.
|
| 5. |
After installing the Side Impact Sensor, confirm proper system operation
:
|
Components 1. Side Impact Sensor (SIS)
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.
Diagnosis with Diagnostic tool 1. In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (Diagnostic tool). The diagnostic system (Diagnostic tool) provides the following information.