Hyundai Venue: Suspension System / Front Suspension System

Troubleshooting

Troubleshooting Symptom Possible cause Remedy Hard steering Improper front wheel alignment Correct Excessive turning resistance of lower arm ball joint Replace Low tire pressure Adjust No power assist Repair and replace Poor return of steering wheel to center Improper front wheel alignment Correct Poor or rough ride Improper front wheel alignment Correct Malfunctioning shock absorber Repair or replace Broken or worn stabilizer Replace Broken or worn coil spring Replace Worn lower arm bushing Replace the lower arm assembly Abnormal tire wear Improper front wheel alignment Correct Improper tire pressure Adjust Malfunctioning shock absorber Replace Wandering Improper front wheel alignment Correct Poor turning resistance of lower arm ball joint Repair Loose or worn lower arm bushing Retighten or replace Vehicle pulls to one side Improper front wheel alignment Correct Excessive turning resistance of lower arm ball joint Replace Broken or worn coil spring Replace Bent lower arm Repair Steering wheel shimmy Improper front wheel alignment Correct Poor turning resistance of lower arm ball joint Replace Broken or worn stabilizer Replace Worn lower arm bushing Replace Malfunctioning shock absorber Replace Broken or worn coil spring Replace Bottoming Broken or worn coil spring Replace Malfunctioning shock absorber Replace Wheel / tire noise, vibration and harshness concerns are directly related to vehicle speed and are not generally affected by acceleration, coasting or decelerating...

Components and components location

Components 1. Front sub frame 2. Front axle 3. Front stabilizer bar 4. Steering gearbox 5. Front lower arm 6...

Other information:

Hyundai Venue (QX) (2020-2024) Service Manual: Water pump. Repair procedures

Removal 1. Drain the coolant. (Refer to Cooling System - "Coolant") 2. Remove the drive belt. (Refer to Timing System - "Drive Belt") 3...

Hyundai Venue (QX) (2020-2024) Owners Manual: Turn signals and lane change signals

To signal a turn, push down on the lever for a left turn or up for a right turn in position (A). If an indicator stays on and does not flash or if it flashes abnormally, one of the turn signal bulbs may be burned out and will require replacement...