Hyundai Venue: Blower / Blower Unit. Components and components location

Hyundai Venue (QX) (2020-2025) Service Manual / Heating, Ventilation and Air Conditioning / Blower / Blower Unit. Components and components location

Component Location

Hyundai Venue. Blower Unit. Components and components location

1. Blower unit assembly

Component Location

Hyundai Venue. Blower Unit. Components and components location

1. Intake seal 2. Intake upper case 3. Intake actuator 4. Intake door 5. Intake lower case 6. Blower pad	7. Blower upper case 8. Climate air filter 9. Power mosfet 10. Resistor 11. Blower lower case 12. Blower motor

Blower

Blower Unit. Repair procedures

Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery / recycling / charging station...

Other information:

Hyundai Venue (QX) (2020-2025) Service Manual: TJ Joint. Components and components location

Components [RH] 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper 6. Shaft 7. TJ boot band 8. TJ boot 9. Spider assembly 10. Snap ring 11. TJ housing 12...

Hyundai Venue (QX) (2020-2025) Service Manual: Description and operation

Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed on upstream and downstream of the Warm up Catalytic Converter (WCC). After it compares oxygen consistency of the atmosphere with the exhaust gas, it transfers the corresponding voltage signal to the ECM...