Hyundai Venue: Manual Temperature Control Mode / Mode selection
The mode selection button controls the direction of the air flow through the ventilation system.
The air flow outlet direction is cycled as follows:
Face-Level (B, D)
Air flow is directed toward the upper body and face. Additionally, each outlet can be controlled to direct the air discharged from the outlet.
Bi-Level (B, C, D)
Air flow is directed towards the face and the floor.
Floor & Defrost (A, C, D)
Most of the air flow is directed to the floor and the windshield with a small amount directed to the side window defrosters.
Floor-Level (A, C, D)
Most of the air flow is directed to the floor, with a small amount of the air being directed to the windshield and side window defrosters.
Manual Temperature Control Mode
The heating and cooling system can be controlled manually by pushing buttons
other than the AUTO button. In this case, the system works sequentially according
to the order of buttons selected...
Instrument panel vents
The instrument panel vent air flow can be directed up/down or left/right using
the vent adjustment lever.
The air flow can also be CLOSED using the vent adjustment lever...
Other information:
Hyundai Venue (QX) (2020-2025) Service Manual: TPMS Sensor. Description and operation
Description 1. General description WU is a sensor placed in the tire that reports pressure and temperature. The WU is mounted inside the wheels, fixed to the valve. The angle between the valve and the housing of the WU is variable...
Hyundai Venue (QX) (2020-2025) Owners Manual: Rear Combination Light Bulb Replacement
Type A (Standard) Type B (LED) (1) Tail lamp (2) Stop/Tail lamp (3) Turn signal lamp (4) Back-up lamp (5) Side marker Stop/tail lamp and turn signal lamp replacement 1. Open the liftgate. 2. Open the lamp assembly retaining screw covers...
Categories
- Manuals Home
- 1st Generation Venue Owners Manual
- 1st Generation Venue Service Manual
- Electronic Stability Control (ESC)
- Type B, C
- Theft-Alarm System
- New on site
- Most important about car
Air bag collision sensors
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:
Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Do not install bumper guards or replace the bumper with a nongenuine HYUNDAI parts. This may adversely affect the collision and air bag deployment performance. Place the ignition switch in the LOCK/OFF or ACC position when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs conducted by an authorized HYUNDAI dealer.
