Hyundai Venue: Heater / Mode Control Actuator. Description and operation
The mode control actuator is located at the heater unit.
It adjusts the position of the mode door by operating the mode control actuator
based on the signal of the A/C control unit. Pressing the mode select switch
makes the mode control actuator shift in order of Vent → Bi-Level → Floor →
Mix.
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the mode control actuator connector...
Other information:
Inspection
1.
Turn OFF ignition switch and disconnect the negative (-) battery cable.
2.
Remove the air cleaner and air duct.
(1)
Remove the air duct (A).
(2)
Disconnect the breather hose (B) and air intake hose (C)...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia panel.
(Refer to Body - "Crash Pad")
3.
Seperate the audio head unit from crash pad after loosening the screws
(4EA)...
Categories
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious
injury or death:
Do not hit or allow any objects to impact the locations where air bags
or sensors are installed.
Do not perform maintenance on or around the air bag sensors. If the location
or angle of the sensors is altered, the air bags may deploy when they should
not or may not deploy when they should.
Do not install bumper guards or replace the bumper with a nongenuine
HYUNDAI parts. This may adversely affect the collision and air bag deployment
performance.
Place the ignition switch in the LOCK/OFF or ACC position when the vehicle
is being towed to prevent inadvertent air bag deployment.
Have all air bag repairs conducted by an authorized HYUNDAI dealer.

read more