Oil Specification |
1. |
The HFC-134a system requires synthetic (PAG) compressor oil whereas
the R-12 system requires mineral compressor oil. The two oils must never
be mixed.
|
2. |
Compressor (PAG) oil varies according to compressor model. Be sure to
use oil specified for the model of compressor.
|
1. |
The oil should be free from moisture, dust, metal powder, etc.
|
2. |
Do not mix with other oil.
|
3. |
The water content in the oil increases when exposed to air. After use,
seal oil from air immediately. (HFC-134a Compressor Oil absorbs moisture
very easily.)
|
4. |
The compressor oil must be stored in steel containers, not in plastic
containers.
|
Oil total volume in system
PAG 30 120 ± 10cc (4.23 ± 0.35oz.)
|
1. |
Open all the doors and engine hood.
|
2. |
Start the engine and air conditioning switch to "ON" and set the blower
motor control knob at its highest position.
|
3. |
Run the compressor for more than 20 minutes between 800 and 1,000 rpm
in order to operate the system.
|
4. |
Stop the engine.
|
This gauge indicates the approximate amount of fuel remaining in the fuel tank.
Information
The fuel tank capacity is given in chapter 2. The fuel gauge is supplemented by a low fuel warning light, which will illuminate when the fuel tank is nearly empty. On inclines or curves, the fuel gauge pointer may fluctuate or the low fuel warning light may come on earlier than usual due to the movement of fuel in the tank.