Hyundai Venue: Engine Control System / Accelerator Position Sensor (APS). Description and operation
Hyundai Venue (QX) (2020-2025) Service Manual / Engine Control / Fuel System / Engine Control System / Accelerator Position Sensor (APS). Description and operation
| Description |
Accelerator Position Sensor (APS) is installed on the accelerator pedal module
and detects the rotation angle of the accelerator pedal. The APS is one of the
most important sensors in engine control system, so it consists of the two sensors
which adapt individual sensor power and ground line. The second sensor monitors
the first sensor and its output voltage is half of the first one. If the ratio
of the sensor 1 and 2 is out of the range (approximately 1/2), the diagnostic
system judges that it is abnormal.
Repair procedures
Inspection
Wave form
1.
Check signal waveform of HO2S using a diagnostic tool.
Specification : Refer to "Waveform"
Heater Resistance
1...
Accelerator Position Sensor (APS). Specifications
Specification
Items
Specification
APS 1
APS 2
C.T
0...
Other information:
Hyundai Venue (QX) (2020-2025) Service Manual: Repair procedures
Removal Brake Hose [Front] 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the brake fluid level sensor connector (A). 3...
Hyundai Venue (QX) (2020-2025) Owners Manual: Drive Mode Integrated Control System
The drive mode may be selected according to the driver's preference or road condition. The system resets to be in the NORMAL mode, when the engine is restarted. Information If there is a problem with the instrument cluster, the drive mode will be in NORMAL mode and may not change to SPORT mode...
Categories
- Manuals Home
- 1st Generation Venue Owners Manual
- 1st Generation Venue Service Manual
- Trip Computer
- Type B, C
- Child-Protector Rear Door Locks
- New on site
- Most important about car
Air bag collision sensors
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:
Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Do not install bumper guards or replace the bumper with a nongenuine HYUNDAI parts. This may adversely affect the collision and air bag deployment performance. Place the ignition switch in the LOCK/OFF or ACC position when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs conducted by an authorized HYUNDAI dealer.
Copyright © 2025 www.hvenueqx.com