| Inspection |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front door trim.
(Refer to Body - "Front door trim")
|
| 3. |
Disconnect the power door mirror connector from the harness
|
| 4. |
Check that the mirror operates properly as shown in the below table.
|
| Removal |
| 1. |
Disconnect (-) battery terminal.
|
| 2. |
Using a fastener remover (C), remove the mirror (A) as illustration
below.
|
| 3. |
Disconnect heat wire connectors (A) and then remove the mirror.
|
| Installation |
| 1. |
Connect mirror heat wire connector and then install the mirror.
|
| 2. |
Connect (-) battery terminal then check if mirror works normally.
|
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim.
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7.
Description and Operation Blcok Diagram • This system monitors the driving situations through the radar and the camera. Thus, for a situation out of the sensing range, the system may not normally operate.