Hyundai Venue (QX): TailGate / Tail Gate Trim. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / TailGate / Tail Gate Trim. Repair procedures

Replacement
Hyundai Venue. Tail Gate Trim. Repair procedures   
•
Put on gloves to prevent hand injuries.
Hyundai Venue. Tail Gate Trim. Repair procedures   
•
When removing with a flat-tip screwdriver or remover,wrap protective tape around the tools to preventdamage to components.
•
Take care not to scratch the body surface.
1.
Loosen the mounting screw and remove the tailgatetrim (A).

Hyundai Venue. Tail Gate Trim. Repair procedures
2.
To install, reverse removal procedure.
Hyundai Venue. Tail Gate Trim. Repair procedures   
•
Replace any damaged clips.

    Component Location 1. Tailgate trim

    Replacement 1. Using a flat-tip screwdriver, lift up slightly the socket clips (A) of both ends on the lifter (B), and then remove the lifter from the bracket.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Intake Actuator. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4.

    Hyundai Venue (QX) (2020-2026) Service Manual: Rear Corner Radar Unit. Repair procedures

    Removal    lf replacement of the rear corner radar unit bracket or extension wire is required, replace the defective part only with a new one. 1.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0156