Hyundai Venue: Sunroof / Sliding the sunroof

Hyundai Venue (QX) (2020-2025) Owners Manual / Convenient Features / Sunroof / Sliding the sunroof

Pressing the sunroof control lever backward or forward momentarily to the second detent position, the sunroof will slide to the recommended open position before the maximum slide open position. To stop the sunroof sliding at any point, push the sunroof control lever momentarily.

To open the sunroof to the maximum slide open position, press the lever backward when the sunroof completely opens and hold it until the sunroof slide all the way open.

Pressing the sunroof control lever forward to the sunroof control lever forward to the second detent position, the sunroof will close all the way. To stop the sunroof sliding at any point, pull or push the sunroof control lever momentarily.

Information

To reduce wind noise while driving, we recommend you to drive at the position before the maximum slide open position.

Sunroof opening and closing

To open the sunroof: Press the sunroof control lever backward to the first detent position. Release the switch when you want the sunroof to stop. To close the sunroof: Press the sunroof control lever forward to the first detent position...

Tilting the sunroof

Tilt the sunroof open: Push the sunroof control lever upward until the sunroof moves to the desired position. To close the sunroof: Push the sunroof control lever forward until the sunroof moves to the desired position...

Other information:

Hyundai Venue (QX) (2020-2025) Owners Manual: Floor Mat Anchor(s)

ALWAYS use the Floor Mat Anchors to attach the front floor mats to the vehicle. The anchors on the front floor carpet keep the floor mats from sliding forward. WARNING Do not overlay additional mats or liners over the floor mats. If using All Weather mats, remove the carpeted floor mats before installing them...

Hyundai Venue (QX) (2020-2025) Service Manual: Sunroof Motor. Repair procedures

Inspection 1. Disconnect the negative battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly") 3. Ground the terminals as below table, and check that the sunroof unit operates after disconnecting the sunroof motor connector...