Hyundai Venue: Interior Trim / Rear Transverse Trim. Repair procedures
• |
Put on gloves to prevent hand injuries.
|
• |
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
• |
Use a plastic panel removal tool to remove interior trim pieces
without marring the surface.
|
• |
Take care not to bend or scratch the trim and panels.
|
|
1. |
Remove the luggage covering bord (A).
|
2. |
Loosen the mounting clips and remove the rear transverse trim (A).
|
3. |
To install, reverse removal procedure.
•
|
Replace any damaged clips (or pin-type retainers).
|
|
|
Other information:
Removal and Installation
1.
Remove the engine cover.
(Refer to Engine and Transaxle Assembly - "Engine Cover")
2.
Disconnect the battery negative terminal.
3...
Removal
[Rear Drum Brake Type]
1.
Disconnect the negative (-) battery cable.
2.
Release the parking brake.
3.
Remove the floor console assembly.
(Refer to Body - "Floor Console")
4...
Categories
This gauge indicates the approximate amount of fuel remaining in the fuel tank.
Information
The fuel tank capacity is given in chapter 2.
The fuel gauge is supplemented by a low fuel warning light, which will
illuminate when the fuel tank is nearly empty.
On inclines or curves, the fuel gauge pointer may fluctuate or the low
fuel warning light may come on earlier than usual due to the movement of fuel
in the tank.
read more