Hyundai Venue: Rear Door / Rear Door Window Glass. Repair procedures
• |
When removing with a flat-tip screwdriver or remover,wrap protective
tape around the tools to preventdamage to components.
|
• |
Take care not to scratch the body surface.
|
|
1. |
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
|
2. |
Remove the plug hole (A).

|
3. |
By operating the power window switch, pull down until the glass mounting
bolt on plug hole is visible.
|
4. |
Remove the rear door inside weatherstrip (A).

|
5. |
Loosen the mounting screw and remove the rear door outside weatherstrip
(A).

|
6. |
Loosen the mounting screw, nut and remove the rear delta fixed glass
(A).

|
7. |
Loosen the mounting bolt and then pull out the rear door window glass
(A) by tilting it sideways.
Tightening torque :
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)
|
•
|
Be careful not to damage the glass surface.
|
|

|
8. |
To install, reverse removal procedure.
•
|
Make sure that the glass rolls up and down smoothly.
|
•
|
Adjust glass position as needed.
|
•
|
Make sure the door locks and opens properly.
|
•
|
Replace any damaged clips (or pin-type retainers).
|
|
|
Other information:
Check LKA system
If there is a problem with the system a message will appear for a few seconds.
If the problem continues LKA system failure indicator will illuminate.
LKA system failure indicator
LKA system failure indicator (yellow) will illuminate if the LKA system is not
working properly...
Removal
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
Cut the heat welds with a knife and remove the front door inside handle
(A).
•
Cut the heat welds with a knife, paying attention to
damage...
Categories

Your HYUNDAI uses a remote key, which you can use to lock or unlock the driver
and passenger doors or the rear liftgate.
(1) Door Lock
(2) Door Unlock
(3) Panic
Locking Your Vehicle
To lock your vehicle:
1. Make sure all doors, the engine hood and the liftgate are closed.
read more