Hyundai Venue: Rear Door / Rear Door Trim. Repair procedures
| • |
When removing with a flat-tip screwdriver or remover,wrap protective
tape around the tools to preventdamage to components.
|
| • |
Take care not to scratch the body surface.
|
|
| 1. |
Loosen the mounting screw and remove the rear door trim (A).

|
| 2. |
Press the lock pin and separate the rear door inside handle case (A)
and power window connector (B).

|
| 3. |
To install, reverse removal procedure.
| •
|
Make sure the connector is connected properly.
|
| •
|
Make sure the door locks / unlocks and opens / closes
properly.
|
| •
|
Replace any damaged clips (or pin-type retainers).
|
| •
|
Make sure the glass is operated properly.
|
|
|
Other information:
When the wipers no longer clean adequately, the blades may be worn or cracked,
and require replacement.
NOTICE
To prevent damage to the wiper arms or other components, do not attempt to
move the wipers manually.
NOTICE
The use of a non-specified wiper blade could result in wiper malfunction and
failure...
Removal
1.
Turn ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Remove the drive belt.
(Refer to Engine Mechanical System - "Drive Belt")
3...
Categories

This gauge indicates the approximate amount of fuel remaining in the fuel tank.
Information
The fuel tank capacity is given in chapter 2.
The fuel gauge is supplemented by a low fuel warning light, which will
illuminate when the fuel tank is nearly empty.
On inclines or curves, the fuel gauge pointer may fluctuate or the low
fuel warning light may come on earlier than usual due to the movement of fuel
in the tank.
read more