Hyundai Venue: Front Bumper / Radiator Grill. Repair procedures

Hyundai Venue (QX) (2020-2024) Service Manual / Body (Interior and Exterior) / Front Bumper / Radiator Grill. Repair procedures

Replacement
Hyundai Venue. Radiator Grill. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front bumper cover.
(Refer to Front Bumper - "Front Bumper Cover")
2.
Remove the front bumper energy absorber (A).

Hyundai Venue. Radiator Grill. Repair procedures
3.
Loosen the mounting screws, remove the front bumper upper cover (A).

Hyundai Venue. Radiator Grill. Repair procedures
4.
Loosen the mounting screws and remove the radiator grill (A).

Hyundai Venue. Radiator Grill. Repair procedures
5.
To install, reverse removal procedure.
Hyundai Venue. Radiator Grill. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Radiator Grill. Components and components location

    ..

    Front Bumper Beam Assembly. Components and components location

    ..

    Other information:

    Hyundai Venue (QX) (2020-2024) Service Manual: Transaxle Control Module (TCM). Schematic diagrams


    TCM Connector Connector [A] Pin Description 2 35R clutch control solenoid valve (35R/C_VFS) 4 26 brake control solenoid valve (26/B_VFS) 5 Underdrive brake control solenoid valve (UD/B_VFS) 8 Inhibitor switch signal S2 (R) 19 Line pressure control solenoid valve (LINE_VFS) 21 Input speed sensor power 22 Output speed sensor power 32 Torque converter control solenoid valve (T/CON_VFS) 33 VB (Battery voltage) 34 Solenoid supply power 2 37 Output speed sensor signal 38 Inhibitor switch signal S4 (D) 39 Inhibitor switch signal S1 (P) 40 Manual mode up shift 42 Manual mode select switch 43 Oil temperature sensor (+) 45 VB (Battery voltage) 46 ON/OFF solenoid valve A(SS-A) 47 Overdrive clutch control solenoid valve (OD/C_VFS) 48 VB (Battery voltage) 49 Solenoid supply power 1 52 Input speed sensor signal 54 Inhibitor switch signal S3 (N) 57 Manual mode down shift 58 Oil temperature sensor (-) TCM Terminal input/ output signal Connector [A] Pin Description Condition Input/output value Type Level 2 35R clutch control solenoid valve (35R/C_VFS) - Output 0V/Battery voltage level 9V < Battery voltage level < 16V 4 26 brake control solenoid valve (26/B_VFS) - Output 0V/Battery voltage level 9V < Battery voltage level < 16V 5 Underdrive brake control solenoid valve (UD/B_VFS) - Output 0V/Battery voltage level 9V < Battery voltage level < 16V 8 Inhibitor switch signal S2 (R) High Input 0V/Battery voltage level Low 9V < Battery voltage level < 16V 19 Line pressure control solenoid valve (LINE_VFS) - Output 0V/Battery voltage level 9V < Battery voltage level < 16V 21 Input speed sensor power ON Power 0V/9V OFF 22 Output speed sensor power ON Power 0V/9V OFF 32 Torque converter control solenoid valve (T/CON_VFS) - Output 0V/Battery voltage level 9V < Battery voltage level < 16V 34 Solenoid power 2 Power 0V/Battery voltage level 9V < Battery voltage level < 16V 37 Output speed sensor signal High Input 0...

    Hyundai Venue (QX) (2020-2024) Service Manual: Tail Gate Assembly. Components and components location


    ..

    Categories

    Smart Key

    Hyundai Venue. Smart Key

    Your HYUNDAI uses a Smart Key, which you can use to lock or unlock the driver and passenger doors or the rear liftgate.

    1. Door Lock
    2. Door Unlock
    3. Remote start

    read more


     
    Copyright © 2024 www.hvenueqx.com