Hyundai Venue: Power Door Locks / Power Door Lock Switch. Repair procedures

Hyundai Venue (QX) (2020-2024) Service Manual / Body Electrical System / Power Door Locks / Power Door Lock Switch. Repair procedures

Diagnosis with GDS

In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (Diagnostic tool).

The diagnostic system(Diagnostic tool) provides the following information.

(1)	The diagnostic system(Diagnostic tool) provides the following information.

(2)	Data Analysis : Checking the system input/output data state.

(3)	Actuation test : Checking the system operation condition.

(4)	S/W Management : Controlling other features including system option setting and zero point adjustment

2.	If diagnose the vehicle by GDS, select "DTC Analysis" and "Vehicle".

3.	If check current status, select the "Data Analysis" and "Car model".

4.	Select the 'ICU' to search the current state of the input/output data.

5.	To forcibly actuate the input value of the module to be checked, select option 'Actuation Test'.

Removal

Driver Power Window Switch

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front door trim. (Refer to Body - "Front Door Trim")

3.	Remove the power window switch assembly (A) by pulling out both ends of the switch holders.

Installation

Driver Power Window Switch

1.	Install the power window switch assembly.

2.	Install the front door trim after connect the connector.

Power Door Lock Actuators. Repair procedures

Inspection Front Door Lock Module Inspection 1. Remove the front door trim. (Refer to Body - "Front Door Trim") 2...

Other information:

Hyundai Venue (QX) (2020-2024) Service Manual: Luggage Side Trim. Components and components location

Hyundai Venue (QX) (2020-2024) Service Manual: Rear Wheel Speed Sensor. Components and components location

Categories

Air bag collision sensors

WARNING

To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:

Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Do not install bumper guards or replace the bumper with a nongenuine HYUNDAI parts. This may adversely affect the collision and air bag deployment performance. Place the ignition switch in the LOCK/OFF or ACC position when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs conducted by an authorized HYUNDAI dealer.

Hyundai Venue. Air bag collision sensors