Hyundai Venue: Lubrication System / Oil Pan. Repair procedures
1. |
Disconnect the battery negative terminal.
|
2. |
Remove the engine room under cover.
|
3. |
Drain the engine oil.
(Refer to Lubrication System - "Engine Oil")
|
4. |
Using the SST (09215-3C000) and remove the oil pan (A).

•
|
Insert the SST between the oil pan and the ladder frame
by tapping it with a plastic hammer in the direction
of ① arrow.
|
•
|
After tapping the SST with a plastic hammer along the
direction of ② arrow around more than 2/3 edge of the
oil pan, remove it from the ladder frame.
|
|
•
|
Do not turn over the SST abruptly without tapping. It
be result in damage of the SST.
|
|
|
1. |
Install the oil pan.
(1) |
Using a razor blade and gasket scraper, remove all the old packing
material from the gasket surfaces.
• |
Check that the mating surfaces are clean and
dry before applying liquid gasket.
|
|
|
(2) |
Apply liquid gasket as an even bead, centered between the edges
of the mating surface.
Liquid gasket : TB 1217H or LOCTITE 5900H
|
• |
To prevent leakage of oil, apply liquid gasket
to the inner threads of the bolt holes.
|
• |
Do not install the parts if five minutes or
more have elapsed since applying the liquid
gasket.
Instead, reapply liquid gasket after removing
the residue.
|
• |
After assembly, wait at least 30 minutes before
filling the engine with oil.
|
|
|
(3) |
Install the oil pan (A) with the bolts.
Uniformly tighten the bolts in several passes.
Tightening torque :
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)
|

|
|
2. |
Refill the engine oil.
Capacity
Total : 3.7 - 4.0L (3.90 - 4.22 US qt, 3.25 - 3.51 lmp qt, 0.97
- 1.05 US gal)
Oil pan : 3.3L (3.48US qt, 2.90lmp qt, 0.87 US gal)
Drain and refill in cluding oil filter :
3.6L (3.80US qt, 3.16lmp qt, 0.95 US gal)
|
|
3. |
Install in the reverse order of removal.
|
Removal and Installation
1.
Remove the oil level gauge & rod (A).
Tightening torque :
9...
Other information:
The manual transmission has 6 forward gears. The transmission is fully synchronized
in all forward gears so shifting to either a higher or a lower gear can be easily
accomplished.
WARNING
Before leaving the driver's seat, always make sure the shift lever is in 1st
gear when the vehicle is parked on a uphill and in R (Reverse) on a downhill, set
the parking brake, and place the ignition switch in the LOCK/OFF position...
Brake System Bleeding
Nomal Brake System
•
Do not reuse the drained fluid.
•
Always use genuine DOT4 brake Fluid...
Categories

1. Instrument cluster
2. Horn
3. Key ignition switch/ Engine Start/Stop button
4. Infotainment system
5. Hazard warning flasher switch
read more