Hyundai Venue: Blower / Intake Actuator. Description and operation
Hyundai Venue (QX) (2020-2025) Service Manual / Heating, Ventilation and Air Conditioning / Blower / Intake Actuator. Description and operation
| Description |
The intake actuator is located at the blower unit. It regulates the intake door
by a signal from the control unit. Pressing the intake selection switch will
shift between recirculation and fresh air modes.
Intake Actuator. Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the intake actuator connector.
3...
Other information:
Hyundai Venue (QX) (2020-2025) Service Manual: Fuel Filler Cap. Description and operation
Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which seals the fuel filler. After the gasket on the fuel filler cap and the filler neck flange contact each other, the ratchet produces a loud clicking noise indicating the seal has been set...
Hyundai Venue (QX) (2020-2025) Service Manual: Wheel. Repair procedures
Hub Nut Tightening Sequence Tighten the hub nuts as follows. Tightening torque : 107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft) • When using an impact gun, final tightening torque should be checked using a torque wrench...
Categories
- Manuals Home
- 1st Generation Venue Owners Manual
- 1st Generation Venue Service Manual
- Remote start
- Rear Combination Light Bulb Replacement
- Trip Computer
- New on site
- Most important about car
Fuel gauge
This gauge indicates the approximate amount of fuel remaining in the fuel tank.
Information
The fuel tank capacity is given in chapter 2. The fuel gauge is supplemented by a low fuel warning light, which will illuminate when the fuel tank is nearly empty. On inclines or curves, the fuel gauge pointer may fluctuate or the low fuel warning light may come on earlier than usual due to the movement of fuel in the tank.
Copyright © 2025 www.hvenueqx.com