Hyundai Venue (QX): Hood / Hood Latch Release Handle. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Release Handle. Repair procedures

Replacement
1.
Pull out the hood latch release handle.
2.
Separate the hood latch release handle cable (A).

Hyundai Venue. Hood Latch Release Handle. Repair procedures
3.
Loosen the mounting screws and remove the hood latch release handle (A).

Hyundai Venue. Hood Latch Release Handle. Repair procedures
4.
Install in the reverse order of removal.
Hyundai Venue. Hood Latch Release Handle. Repair procedures   
•
Make sure the hood latch cable is connected properly.
•
Make sure the hood locks / unlocks and opens / closes properly.

    Component Location 1. Hood latch release handle

    Component Location 1. Hood latch assembly

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Receiver-Drier. Repair procedures

    Replacement 1. Remove the condenser. 2. Remove the cap (A) on the bottom of the condenser with a L wrench. Tightening torque : 9.81 - 14.71 N.m (1.

    Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Description and operation

    Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0191