Hyundai Venue (QX): Body Side Molding / Front Wheel Guard. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Body Side Molding / Front Wheel Guard. Repair procedures

Replacement
Hyundai Venue. Front Wheel Guard. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Take care not to scratch the body surface.
1.
Remove the front tire.
2.
Loosen the mounting clip, nuts and screws and remove the front wheel guard (A).

Hyundai Venue. Front Wheel Guard. Repair procedures
3.
To install, reverse removal procedure.
Hyundai Venue. Front Wheel Guard. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Replacement    • Put on gloves to prevent hand injuries.

    Replacement    • Put on gloves to prevent hand injuries.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Special service tools

    Special Service Tools Tool Name / Number Illustration Description LKA Compensator (09890-3V100) Used for compensating front view camera unit BCW Sensor Correction Tool Set (09958-3T500) Used to correct the blin

    Hyundai Venue (QX) (2020-2026) Service Manual: Description and operation

    Description Rear Corner Radar is a system that measures the relative speed and distance from the following vehicles by using two electromagnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0216