Hyundai Venue (QX): Body (Interior and Exterior) / Body Side Molding
- Fender Garnish. Repair procedures
- Quarter Garnish. Repair procedures
- Front Wheel Guard. Repair procedures
- Rear Wheel Guard. Repair procedures
- Door Garnish. Repair procedures
- Side Sill Molding. Repair procedures
- Roof Side Molding. Repair procedures
- Roof Rack. Components and components location
- Roof Rack. Repair procedures
Replacement • When removing with a flat-tip screwdriver or remover,wrap protective tape around the tools to preventdamage to components.
Replacement • Put on gloves to prevent hand injuries.
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Receiver-Drier. Repair procedures
Replacement 1. Remove the condenser. 2. Remove the cap (A) on the bottom of the condenser with a L wrench. Tightening torque : 9.81 - 14.71 N.m (1.
Hyundai Venue (QX) (2020-2026) Service Manual: PTC Heater. Repair procedures
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Electronic Stability Control (ESC)
- Front Suspension System
- Repair procedures
- New on site
- Most important about car
