Hyundai Venue: Front Door / Front Door Window Glass. Repair procedures
1. |
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
|
2. |
Remove the front door inside weatherstrip (A).

|
3. |
Remove the front door outside weatherstrip (A).

|
4. |
Remove the plug hole (A).

|
5. |
By operating the power window switch, pull down until the glass mounting
bolt on plug hole is visible.
•
|
Be careful not to damage the glass surface.
|
|

|
6. |
Loosen the mounting bolt and then pull out the front door window glass
(A) by tilting it sideways.
Tightening torque :
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)
|

|
7. |
To install, reverse removal procedure.
•
|
Roll the glass up and down to see if it moves freely.
|
•
|
Adjust glass position as needed.
|
•
|
Make sure the door lock and opens properly.
|
•
|
Check the glass run channel for damage and replace the
damaged channel.
|
|
|
Other information:
Inspection
1.
Disconnect the negative battery terminal.
2.
Remove the roof trim assembly.
(Refer to Body - "Roof Trim Assembly")
3.
Ground the terminals as below table, and check that the sunroof unit
operates after disconnecting the sunroof motor connector...
Inspection
The following section describes how to diagnose faults using a diagnostic instrument.
1.
Connect the cable of GDS to the data link connector in driver side crash
pad lower panel, and turn on the GDS...
Categories
Vehicle Identification Number (vin)

Frame number
read more