Hyundai Venue: Advanced Driver Assistance System (ADAS) / Description and operation
Hyundai Venue (QX) (2020-2024) Service Manual / Advanced Driver Assistance System (ADAS) / Description and operation
| Description |
Advanced Driver Assistance System (ADAS) analyzes the exterior environment of
a vehicle and driver status to provide visibility / display / guide / warning
for driving and parking.
|
Item |
Function |
Explanation |
Unit |
|||||
|
Front Radar |
Front View Camera |
Rear Corner Radar |
Rear View Camera |
PDW Sensor |
||||
|
Driving |
Safety |
FCA |
Forward Collision-Avoidance Assist |
● |
● |
|
|
|
|
LKA |
Lane Keeping Assist |
|
● |
|
|
|
||
|
DAW |
Driver Attention Warning |
|
● |
|
|
|
||
|
BCW |
Blind-Spot Collision Warning |
|
|
● |
|
|
||
|
HBA |
High Beam Assist |
|
● |
|
|
|
||
|
Parking |
Safety |
RCCW |
Rear Cross-Traffic Collision Warning |
|
|
● |
|
|
|
RVM |
Rear View Monitor |
|
|
|
● |
|
||
|
Convenience |
PDW |
Parking Distance Warning |
|
|
|
|
● |
|
Special service tools
Special Service Tools
Tool Name / Number
Illustration
Description
LKA Compensator
(09890-3V100)
Used for compensating front view camera unit
BCW Sensor Correction Tool Set
(09958-3T500)
Used to correct the blind-spot radar unit...
Other information:
Hyundai Venue (QX) (2020-2024) Service Manual: PDM (Power Distribution Module). Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the MDPS. (Refer to Steering System - "Motor Driven Power Steering") 3. Remove the PDM relay box (A) after mouting nuts and disconnecting the connector...
Hyundai Venue (QX) (2020-2024) Service Manual: Radiator. Repair procedures
Removal and Installation • Never remove the radiator cap when the engine is hot. Serious scalding could be caused by hot fluid under high pressure escaping from the radiator...
Categories
- Manuals Home
- 1st Generation Venue Owners Manual
- 1st Generation Venue Service Manual
- Remote Key
- Rear Combination Light Bulb Replacement
- Check Tire Pressure
- New on site
- Most important about car
Air bag collision sensors
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:
Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Do not install bumper guards or replace the bumper with a nongenuine HYUNDAI parts. This may adversely affect the collision and air bag deployment performance. Place the ignition switch in the LOCK/OFF or ACC position when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs conducted by an authorized HYUNDAI dealer.
Copyright © 2024 www.hvenueqx.com