| Removal |
| 1. |
Disconnect the battery negative cable and wait for at least 3 minutes
before beginning work.
|
| 2. |
Remove the roof trim.
(Refer to Body - "Roof Trim Assembly")
|
| 3. |
Remove the curtain airbag after disconnecting the curtain airbag harness
connector and loosening the mounting bolts.
|
| Installation |
| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable and wait for at least three minutes.
|
| 3. |
Tighten the curtain airbag mounting bolts.
|
| 4. |
Connect the curtain airbag connector.
|
| 5. |
Install the roof trim.
(Refer to Body - "Roof Trim Assembly")
|
| 6. |
Reconnect the battery negative cable.
|
| 7. |
After installing the curtain airbag (CAB), confirm proper system operation
:
|
Components 1. Curtain Air Bag (CAB)
Airbag Disposal When you scrap a vehicle equipped with an airbag, you must deploy it first. When you deploy an airbag, you need to have a skilled mechanic do the work.
Component Location 1. Heater unit assembly Compoents 1. Mode control actuator 2. Heater core case 3. Center duct seal 4. PTC heater 5. Heater core assembly 6. Heater case [LH] 7.
Removal lf replacement of the rear corner radar unit bracket or extension wire is required, replace the defective part only with a new one. 1.