Hyundai Venue: Interior Trim / Cowl Side Trim. Repair procedures

Hyundai Venue (QX) (2020-2025) Service Manual / Body (Interior and Exterior) / Interior Trim / Cowl Side Trim. Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the front door scuff trim. (Refer to Interior Trim - "Door Scuff Trim")

2.	Using a flat-tip screwdriver or remover, remove the cowl side trim (A).

To install, reverse removal procedure.

•	Replace any damaged clips (or pin-type retainers).

Cowl Side Trim. Components and components location

Front Pillar Trim. Components and components location

Other information:

Hyundai Venue (QX) (2020-2025) Service Manual: Cooling Fan. Repair procedures

Removal and Installation Cooling Fan Assembly 1. Disconnect the battery negative terminal. 2. Remove the air duct. (Refer to Intake and Exhaust System - "Air Cleaner") 3...

Hyundai Venue (QX) (2020-2025) Service Manual: Rear Transverse Trim. Components and components location

Categories

Master warning mode

Hyundai Venue. Master warning mode

This warning light informs the driver the following situations.

-- Forward Collision-Avoidance Assist system malfunction (if equipped)
-- Forward Collision-Avoidance Assist radar blocked (if equipped)
-- Blind-Spot Collision Warning system malfunction (if equipped)
-- Blind-Spot Collision Warning radar blocked (if equipped)
-- Lamp malfunction (if equipped)
-- High Beam Assist malfunction (if equipped)
-- Tire Pressure Monitoring System (TPMS) malfunction (if equipped)