Hyundai Venue: SRSCM / Components and components location
Hyundai Venue (QX) (2020-2024) Service Manual / Restraint / SRSCM / Components and components location
| Components |
| 1. Front right Impact Sensor
(FIS) 2. Supplemental Restraint System Control Module (SRSCM) |
3. Gravity Side Impact Sensor
(G-SIS) |
SRSCM
..
Other information:
Hyundai Venue (QX) (2020-2024) Service Manual: Description and operation
Description Rear view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle through the AV monitor or the ECM (Reverse Display Room Mirror) mirror while backing-up...
Hyundai Venue (QX) (2020-2024) Service Manual: Front Wheel Guard. Repair procedures
Replacement • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...
Categories
- Manuals Home
- 1st Generation Venue Owners Manual
- 1st Generation Venue Service Manual
- Rear Combination Light Bulb Replacement
- Remote start
- Operating Door Locks from Outside the Vehicle
- New on site
- Most important about car
Air bag collision sensors
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:
Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Do not install bumper guards or replace the bumper with a nongenuine HYUNDAI parts. This may adversely affect the collision and air bag deployment performance. Place the ignition switch in the LOCK/OFF or ACC position when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs conducted by an authorized HYUNDAI dealer.
Copyright © 2024 www.hvenueqx.com