Hyundai Venue (QX): Tires and Wheels / Wheel Alignment and Tire Balance
The wheels on your vehicle were aligned and balanced carefully at the factory to give you the longest tire life and best overall performance.
In most cases, you will not need to have your wheels aligned again. However, if you notice unusual tire wear or your vehicle pulling one way or the other, the alignment may need to be reset.
If you notice your vehicle vibrating when driving on a smooth road, your wheels may need to be rebalanced.
NOTICE
Improper wheel weights can damage your vehicle’s aluminum wheels. Use only approved wheel weights.
To equalize tread wear, HYUNDAI recommends that the tires be rotated according to the maintenance schedule or sooner if irregular wear develops. During rotation, check the tires for correct balance.
If the tire is worn evenly, a tread wear indicator will appear as a solid band across the tread. This shows there is less than 2/32 inch (1.6 mm) of tread left on the tire.
Other information:
Hyundai Venue (QX) (2020-2025) Service Manual: Heater Unit. Components and components location
Component Location 1. Heater unit assembly Compoents 1. Mode control actuator 2. Heater core case 3. Center duct seal 4. PTC heater 5. Heater core assembly 6. Heater case [LH] 7.
Hyundai Venue (QX) (2020-2025) Service Manual: Temperature Control Actuator. Description and operation
Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Remote Key
- Tire Pressure Monitoring System (TPMS) (Type A)
- Warning and Indicator Lights
- New on site
- Most important about car
