Hyundai Venue: Heating, Ventilation and Air Conditioning / Troubleshooting

Hyundai Venue (QX) (2020-2025) Service Manual / Heating, Ventilation and Air Conditioning / Troubleshooting

Troubleshooting

Problem Symptoms Table

Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor.

Use the table below to help you find the cause of the problem. The numbers indicate the priority of the likely cause of the problem. Check each part in order. If necessary, replace these parts.

After correcting the malfunction, check the complete system to ensure that performance is satisfactory.

Standard:

Symptom	Suspected Area
No blower operation	1. Blower fuse
	2. Blower relay
	3. Blower motor
	4. Power mosfet
	5. Blower speed control switch
	6. Wire harness
No air temperature control	1. Engine coolant capacity
No air temperature control	2. Heater control assembly
No compressor operation	1. Refrigerant capacity
	2. A/C fuse
	3. Compressor
	4. A/C pressure transducer
	5. A/C switch
	6. Evaporator temperature sensor
	7. Wire harness
Vented air not cold	1. Refrigerant capacity
	2. Refrigerant pressure
	3. Drive belt
	4. Compressor
	5. A/C pressure transducer
	6. Evaporator temperature sensor
	7. A/C switch
	8. Heater control assembly
	9. Wire harness
Insufficient cooling	1. Refrigerant capacity
	2. Drive belt
	3. Compressor
	4. Condenser
	5. Expansion valve
	6. Evaporator
	7. Refrigerant lines
	8. A/C pressure transducer
	9. Heater control assembly
No engine idle-up when A/C switch ON	1. Engine ECM
No engine idle-up when A/C switch ON	2. Wire harness
No air inlet control	1. Heater control assembly
No mode control	1. Heater control assembly
No mode control	2. Mode actuator
No cooling fan operation	1. Cooling fan fuse
	2. Fan motor
	3. Engine ECM
	4. Wire harness

Specifications

Specification Air Conditioner item Specification Compressor Type DVE12N Oil type & Capacity PAG 30 120 ± 10cc (4...

Special service tools

Special Service Tools Tool (Number and name) Illustration Use 09977-3R000 Disc & hub assembly bolt remover Removal and installation of disc & hub assembly...

Other information:

Hyundai Venue (QX) (2020-2025) Service Manual: Repair procedures

Inspection Throttle Position Sensor (TPS) 1. Connect a diagnostic tool on the Data Link Connector (DLC). 2. Start engine and check output voltages of TPS 1 and 2 at C.T and W.O.T. [TPS 1] Conditon Throttle Angle (◦) Output voltage (V) [Vref =5V] C...

Hyundai Venue (QX) (2020-2025) Service Manual: Purge Control Solenoid Valve (PCSV). Description and operation

Description Purge Control Solenoid Valve (PCSV) is a solenoid valve and is installed on the surge tank and controls the passage between the canister and the intake manifold. The evaporative gases gathered in the canister are delivered to the intake manifold when the PCSV is open by ECM control signal...