Hyundai Venue: General Information / Specifications
Ignition Coil
Item
|
Specification
|
Primary Coil Resistance (Ω)
|
0.75 ± 15% [20°C (68°F)]
|
Secondary Coil Resistance (kΩ)
|
5.9 ± 15% [20°C (68°F)]
|
Spark plug
Items
|
Specification
|
Spark plugs
|
Type
|
LZKR6B-10E, RER8MC, ELR9QC10
|
Gap
|
1.0 - 1.1 mm
(0.0394 - 0.0433in.)
|
Condenser
Item
|
Specification
|
Capacitance (uF)
|
0.47 [1KHz]
|
Insulation resistance (MΩ)
|
1,000 [DC 500 V/1 Min]
|
Alternator
Item
|
Specification
|
Rated voltage
|
13.5V, 120A
|
Speed in use
|
1,000 - 18,000 rpm
|
Voltage regulator
|
IC Regulator built-in type
|
Regulator Setting Voltage
|
External mode
|
Refer to below graph
|
Internal mode
|
14.55 ± 0.3V
|
Temperature Gradient
|
External mode
|
0 ± 3 mV / °C
|
Internal mode
|
-3.5 ± 2mV / °C
|
※ Regulator Setting Voltage (External mode)
Battery
Item
|
Specification
|
Model type
|
CMF45L-DIN
|
Capacity [20HR / 5HR] (AH)
|
45 / 36
|
Cold Cranking Amperage (A)
|
410 (SAE / EN)
|
Reserve Capacity (Min)
|
80
|
| • |
Model type description
|
| • |
Cold Cranking Ampere (CCA) : Cold Cranking Amps is a rating
used in the battery industry to define a battery's ability to
start an engine in cold temperatures.
|
| – |
The rating is the number of amps a new, fully charged battery
can deliver at -18°C (-0.4°F) for 30 seconds, while maintaining
a voltage of at least 7.2 volts for a 12 volt battery.
|
| – |
The higher the CCA rating, the greater the starting power of
the battery.
|
| • |
RESERVE CAPACITY (RC) : Reserve Capacity is a battery industry
rating, defining a battery's ability to power a vehicle with
an inoperative alternator or fan belt.
|
| – |
The rating is the number of minutes a battery at 26.7°C (80°F)
can be discharged at 25 amps and maintain a voltage of 10.5
volts for a 12 volt battery.
|
| – |
The higher the reserve rating, the longer your vehicle can operate
should your alternator or fan belt fail.
|
|
Starter
Item
|
Specification
|
Rated voltage
|
12V, 0.9kW
|
The number of pinion teeth
|
10
|
Performance
[No-load, 11.5V]
|
Ampere
|
Max. 60 A
|
Speed
|
Min. 5,500 rpm
|
Item
|
N.m
|
kgf.m
|
lb-ft
|
Ignition coil installation bolt
|
9.8 - 11.8
|
1.0 - 1.2
|
7.2 - 8.7
|
Spark plug installation
|
14.7 - 24.5
|
1.5 - 2.5
|
10.9 - 18.1
|
Condenser bracket installation bolt
|
9.8 - 11.8
|
1.0 - 1.2
|
7.2 - 8.7
|
Alternator installation bolt [12 mm (0.47 in.)]
|
19.6 - 26.5
|
2.0 - 2.7
|
14.5 - 19.5
|
Alternator installation bolt [14 mm (0.55 in.)]
|
29.4 - 41.2
|
3.0 - 4.2
|
21.7 - 30.4
|
Battery (+) terminal tightening nut
|
7.8 - 9.8
|
0.8 - 1.0
|
5.2 - 8.7
|
Battery (-) terminal tightening nut
|
3.9 - 5.9
|
0.4 - 0.6
|
2.9 - 4.3
|
Battery mounting bracket bolt
|
8.8 - 13.7
|
0.9 -1.4
|
6.5 -10.1
|
Battery tray installation bolt
|
8.8 -13.7
|
0.9 -1.4
|
6.5 -10.1
|
Battery sensor cable installation bolt
|
21.6 - 32.4
|
2.2 - 3.3
|
15.9 - 23.9
|
Starter installation bolt
|
49.0 - 63.7
|
5.0 - 6.5
|
36.2 - 47.0
|
Troubleshooting
Ignition System
Symptom
Suspect Area
Remedy
Engine will not start or is hard to
start (Cranks OK)
Ignition lock switch
Inspect ignition lock switch, or replace as required
Ignition coil
Inspect ignition coil, or replace as required
Spark plugs
Inspect spark plugs, or replace as required
Ignition wiring disconnected or broken
Repair wiring, or replace as required
Rough idle or stalls
Ignition wiring
Repair wiring, or replace as required
Ignition coil
Inspect ignition coil, or replace as required
Engine hesitates/poor acceleration
Spark plugs and spark plug cables
Inspect spark plugs / cable, or replace as required
Ignition wiring
Repair wiring, or replace as required
Poor mileage
Spark plugs and spark plug cables
Inspect spark plugs / cable, or replace as required
Charging System
Symptom
Suspect Area
Remedy
Charging warning indicator does not
light with ignition switch "ON" and
engine off...
Other information:
You will find many safety precautions and recommendations throughout this section,
and throughout this manual. The safety precautions in this section are among the
most important.
Always Wear Your Seat Belt
A seat belt is your best protection in all types of accidents...
Inspection
▶ Transaxle Control Module(TCM) Problem Inspection Procedure
1.
TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis
ground using the backside of TCM harness connector as TCM side check
point...
Categories
This gauge indicates the approximate amount of fuel remaining in the fuel tank.
Information
The fuel tank capacity is given in chapter 2.
The fuel gauge is supplemented by a low fuel warning light, which will
illuminate when the fuel tank is nearly empty.
On inclines or curves, the fuel gauge pointer may fluctuate or the low
fuel warning light may come on earlier than usual due to the movement of fuel
in the tank.
read more
Troubleshooting