Hyundai Venue: Body Electrical System / License Lamps
Hyundai Venue (QX) (2020-2025) Service Manual / Body Electrical System / License Lamps
Rheostat. Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel (A)...
Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the license lamp assembly after pushing the fixing clip (A)...
Other information:
Hyundai Venue (QX) (2020-2025) Service Manual: Repair procedures
Removal 1. Remove the front bumper cover. (Refer to Body - "Front Bumper Cover") 2. Disconnect the multifunction switch connector and then remove the low horn (A). Installation 1...
Hyundai Venue (QX) (2020-2025) Owners Manual: Detecting Sensor
The rear corner radars are located inside the rear bumper for detecting the side and rear areas. Always keep the rear bumper clean for proper operation of the system. NOTICE The system may not work properly when the bumper has been damaged, or if the rear bumper has been replaced or repaired...
Categories
- Manuals Home
- 1st Generation Venue Owners Manual
- 1st Generation Venue Service Manual
- Liftgate
- Smart Key
- Immobilizer System
- New on site
- Most important about car
Air bag collision sensors
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:
Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Do not install bumper guards or replace the bumper with a nongenuine HYUNDAI parts. This may adversely affect the collision and air bag deployment performance. Place the ignition switch in the LOCK/OFF or ACC position when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs conducted by an authorized HYUNDAI dealer.
Copyright © 2025 www.hvenueqx.com