| Components |

| 1. Intake manifold 2. Intake manifold gasket 3. Electronic throttle body gasket 4. Electronic throttle body |
5. MAP sensor 6. Vacumm hose 7. PCV hose 8. Variable Intake Solinoid(VIS) |
Removal and Installation 1. Disconnect the battery "-" terminal. 2. Disconnect the Variable Intake Solinoid(VIS) conncetor(A).
Removal and Installation 1. Remove the engine cover. 2. Disconnect the battery negative terminal.
Inspection The following section describes how to diagnose faults using a diagnostic instrument. 1. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS.
Component Location 1. Heater unit assembly Compoents 1. Mode control actuator 2. Heater core case 3. Center duct seal 4. PTC heater 5. Heater core assembly 6. Heater case [LH] 7.