Hyundai Venue (QX): Front Bumper / Front Bumper Beam Assembly. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Front Bumper / Front Bumper Beam Assembly. Repair procedures

Replacement
Hyundai Venue. Front Bumper Beam Assembly. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front bumper cover.
(Refer to Front Bumper - "Front Bumper Cover")
2.
Separate the ambient temperature sensor connector (A) and loosen the mounting clips.

Hyundai Venue. Front Bumper Beam Assembly. Repair procedures
3.
Press the lock pin and separate the front radar connector (A) and loosen the mounting clips.

Hyundai Venue. Front Bumper Beam Assembly. Repair procedures
4.
Loosen the mounting bolts, nuts and remove the front bumper beam assembly (A).
Hyundai Venue. Front Bumper Beam Assembly. Repair procedures   
•
When removing the front bumper rail, engage the fastening bolt for the front bumper rail to align the front end module and keep it in order.

Hyundai Venue. Front Bumper Beam Assembly. Repair procedures
5.
To install, reverse removal procedure.
Hyundai Venue. Front Bumper Beam Assembly. Repair procedures   
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Front bumper beam assembly

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Repair procedures

    Inspection The following section describes how to diagnose faults using a diagnostic instrument. 1. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS.

    Hyundai Venue (QX) (2020-2026) Service Manual: A/C Pressure Transducer. Description and operation

    Description The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by operating it high speed or low speed.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0134