Hyundai Venue: Crash Pad / Crash Pad Side Cover. Repair procedures
• |
Put on gloves to prevent hand injuries.
|
• |
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
• |
Use a plastic panel removal tool to remove interior trim pieces
without marring the surface.
|
• |
Take care not to bend or scratch the trim and panels.
|
|
• |
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
• |
Use a plastic panel removal tool to remove interior trim pieces
without marring the surface.
|
• |
Take care not to bend or scratch the trim and panels.
|
|
1. |
Remove the front door body side weatherstrip.
|
2. |
Using a flat-tip screwdriver or remover and remove the crash pad side
cover (A).
[RH]

[LH]

|
3. |
To install, reverse removal procedure.
•
|
Replace any damaged clips (or pin-type retainers).
|
|
|
Replacement
[Steering column shroud upper panel]
•
Put on gloves to prevent hand injuries...
Replacement
•
Put on gloves to prevent hand injuries...
Other information:
Special Service Tools
Tool (Number and Name)
Illustration
Use
Deployment tool
0957A-34100A
Airbag deployment tool.
Use with (0957A-AL140)
Dummy
0957A-38200
Simulator to check the resistanceof each wiring harness...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the cluster fascia panel.
(Refer to Body - "Cluster Fascia Panel")
3.
Remove the cluster (A) from the housing after loosening the mounting
screws...
Categories
Seat belt warning light (for driver’s seat)

As a reminder to the driver, the seat belt warning light will illuminate for
approximately 6 seconds each time you place the ignition switch to the ON position
regardless of belt fastening. However, if the seat belt is unfasted, a warning chime
will sound for approximately 6 seconds.
read more