| Components |

| 1. Resister 2. Cooling fan 3. Cooling fan motor |
4. Cooling fan shroud 5. Reservoir tank |
Replacement and Air Bleeding • Never remove the radiator cap when the engine is hot.
Removal and Installation Cooling Fan Assembly 1. Disconnect the battery negative terminal. 2. Remove the air duct.
Replacement 1. Remove the condenser. 2. Remove the cap (A) on the bottom of the condenser with a L wrench. Tightening torque : 9.81 - 14.71 N.m (1.
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.