Hyundai Venue: Engine Control System / Accelerator Position Sensor (APS). Repair procedures
1. |
Connect the diagnostic tool on the Diagnosis Link Connector (DLC).
|
2. |
Start engine and check output voltages of APS 1 and 2 at C.T and W.O.T.
Specification : Refer to Specification Section.
|
|
Description
Based on information from various sensors, the ECM can calculate the fuel amount
to be injected. The fuel injector is a solenoid-operated valve and the fuel
injection amount is controlled by length of injection time...
Other information:
Replacement
1.
Using a clip remover, remove the clips and then the hood insulator pad
(A).
•
Be careful not to scratch the hood panel...
1. Start the engine.
2. Set the mode to the desired position. To improve the effectiveness of heating
and cooling, select the mode according to the following:
-- Heating:
-- Cooling:
3. Set the temperature control to the desired position.
4. Set the air intake control to fresh mode or recirculation mode position...
Categories
Your HYUNDAI uses a remote key, which you can use to lock or unlock the driver
and passenger doors or the rear liftgate.
(1) Door Lock
(2) Door Unlock
(3) Panic
Locking Your Vehicle
To lock your vehicle:
1. Make sure all doors, the engine hood and the liftgate are closed.
read more